Monday, 5 November 2018

Go Large

I'm afraid I'm still playing with the printer 🤣 Anyway I thought I'd have a go at scaling up and make a 40mm figure
I don't think it turned out too bad.
Will take some better photos today but pics taken in poor light.
All very promising.


  1. Those look really nice Graham...
    Do you get much in the way of build lines?

    All the best. Aly

    1. Aly,
      Not at all set at 0.02 for the layers and being resin it's harder to see build lines than on fdm . Once painted shall display but overall very pleased next trial next week - go small 🤣

  2. Looking good so far, graham. The figures seem to scale up quite nicely with the printer :)

  3. Thanks for all your efforts that you have put in this, It's very interesting Blog...
    I believe there are many who feel the same satisfaction as I read this article!
    I hope you will continue to have such articles to share with everyone!