Saturday, 6 July 2019

Vauban - the start

Well after the mammoth 22 hour print the first two pieces of the first bastion is complete, the next two pieces I think I will print one at a time.
I scaled it down slightly and printed at 90% - I think it looks fine with the figures - so onwards and upwards


at

7 comments:

  1. StuartInsch6 July 2019 at 11:10

    Watching this with keen interest ....looks great.

    ReplyDelete
  2. Colin Ashton6 July 2019 at 12:29

    Good job I already have a Vauban fortress. What make is the printer?

    ReplyDelete
  3. Der Alte Fritz6 July 2019 at 16:37

    I like what you've done so far. Do you have the software for a main gate?

    ReplyDelete
    Replies
    1. Graham C7 July 2019 at 09:51

      Jim,
      Yes, check out laser dreamworks I have most the files.

      Delete
  4. DaveD6 July 2019 at 20:06

    That looks a good start . Along with the bits you showed me Partizan , I think I need to sort out some cave space to get a printer in there

    ReplyDelete
    Replies
    1. Graham C7 July 2019 at 09:50

      Dave,
      To be honest these are better than the bits at Partizan 😀 I've gone for better quality and the resin printer has been busy 15mm WWII vehicles 🤣

      Delete